American Energy Systems HR-01-B Betriebsanleitung PDF herunterladen

F:\AESBusinessSystems\AES Technical\Piece part instructions\NPS-1005-N-9 Control Panel Kit HR01 New

Stlye.doc

Wire Harness Assembly

Part #PP-1037

For Models HR01 (2011 to present)

• Unplug unit

• Open both side panels.

• Remove existing wire harness.

• May need to cut off existing molex and replace with male/female wire connectors.

• Attach the following:

o Control Board molex connector and black lead to terminal

o Fuel Stirrer motor black wire from control panel to one black lead double white lead

to black lead

o Snap disc right side not used

o Exhaust Fan white wire to one lead blue wire to one lead

o High Limit Snap Disk two orange wires to both leads

o Vacuum Pressure Switch two grey wires to both leads top terminal and middle terminal

o Proof of Fire Snap Disk two brown wires to both leads

o Auger Motor white wire to one lead yellow wire to one lead

o Room Air Fan double white wires to one lead pink wire to one lead

o Electrical Plug double white wires middle terminal black wire bottom terminal

green wire to top terminal other end of green wire screwed to base

of unit

o NOT USED red wire & white wire

• Plug unit in

• Turn on unit

Fuel stirrer lead

terminal

molex

1 2 3 4 5 6 7 8 9

Inhaltsverzeichnis

Seite 1 - Part #PP-1037

F:\AESBusinessSystems\AES Technical\Piece part instructions\NPS-1005-N-9 Control Panel Kit HR01 New Stlye.doc Wire Harness Assembly Part #PP-1037 For

Seite 2 - Stlye.doc

F:\AESBusinessSystems\AES Technical\Piece part instructions\NPS-1005-N-9 Control Panel Kit HR01 New Stlye.doc

Seite 3

F:\AESBusinessSystems\AES Technical\Piece part instructions\NPS-1005-N-9 Control Panel Kit HR01 New Stlye.doc Below is a graphical display of the Cou

Seite 4 - OPERATING INSTRUCTIONS

F:\AESBusinessSystems\AES Technical\Piece part instructions\NPS-1005-N-9 Control Panel Kit HR01 New Stlye.doc OPERATING INSTRUCTIONS (Without using s

Seite 5

F:\AESBusinessSystems\AES Technical\Piece part instructions\NPS-1005-N-9 Control Panel Kit HR01 New Stlye.doc The auger feed rate on each setting is p

Seite 6 - THE CONTROL BOARD DESIGN

F:\AESBusinessSystems\AES Technical\Piece part instructions\NPS-1005-N-9 Control Panel Kit HR01 New Stlye.doc INTRODUCTION This section will explain t

Seite 7 - OPERATION

F:\AESBusinessSystems\AES Technical\Piece part instructions\NPS-1005-N-9 Control Panel Kit HR01 New Stlye.doc INPUT SWITCHES 1. ON/OFF • When presse

Seite 8

F:\AESBusinessSystems\AES Technical\Piece part instructions\NPS-1005-N-9 Control Panel Kit HR01 New Stlye.doc 1.2. RUN mode: Simultaneously @ end of

Seite 9 - SPECIAL NOTE

F:\AESBusinessSystems\AES Technical\Piece part instructions\NPS-1005-N-9 Control Panel Kit HR01 New Stlye.doc c) If High Limit (OT) is OPEN during RUN